November 13, 2026
A dishwasher cleans by spraying hot water and detergent over the dishes from two spinning arms, then draining the dirty water away and drying what is left. When dishes come out dirty, either the wash did not reach them or the dirty water did not leave. The pattern of the dirt tells you which one it is: food left on the top rack points at the upper spray arm, grit on everything points at the filter, and standing water at the bottom points at the drain.
Start with the two checks that need no tools: the filter and the spray arms. The filter sits at the bottom of the tub and catches food, and it is designed to be cleaned. The spray arms spin on a jet of water, and their holes clog with food and mineral deposits over time. Both are common, both are easy to fix, and both are worth ruling out before you call.
Massachusetts homes add their own wrinkles. A dishwasher in a seasonal house in Harwich that sits unused for months can dry out at the seals, and the first wash of the season can leak or clean poorly until the seals soften again. In older kitchens in Salem or Gloucester, a dishwasher that shares its drain with a garbage disposal can back up when the disposal side clogs. The sections below work through the causes in the order a technician would check them.
The filter: the first thing to check
The filter sits at the bottom of the tub, usually a round cylinder that twists out by hand, and its job is to catch food before it reaches the pump. When it fills up, dirty water circulates instead of draining, and the dishes come out with grit on them. This is the single most common cause of a dishwasher that does not clean, and the fix takes five minutes.
Twist the filter out, rinse it under a hot tap, and brush away anything stuck in the mesh. Check the sump underneath it as well — the shallow well the filter sits in — and pick out any food or glass caught there. Put the filter back and twist it until it locks. Run a short cycle with the machine empty: if the water drains cleanly and the next load comes out clean, the filter was the problem. Clean it every week from now on, and scrape plates before loading rather than rinsing them fully — a little food on the plates helps the detergent work.
The spray arms: blocked holes and arms that will not spin
The spray arms sit at the bottom and the top of the tub, and they spin on the pressure of the water pumped through them. Each arm has a row of small holes, and when those holes clog with food or mineral deposits, the water cannot reach the dishes. An arm that is blocked on one side will spin unevenly or not at all, and the rack above it comes out dirty while the rest of the load is clean.
Pull the arms out — they usually lift off or unscrew by hand — and hold them up to a light. Poke each hole clear with a toothpick or a thin wire, and rinse the arm under a hot tap. Spin each arm by hand before you put it back: it should turn freely, with no wobble and no scraping against the rack. If an arm is cracked or its bearing is worn, it will not spin evenly even when clean, and it needs replacing. A new arm is a small part, and a technician can fit one in a single visit.
The drain: standing water at the bottom
If water is left standing at the bottom of the tub after the cycle, the drain is the problem, and the dishes will not be clean because they have been sitting in dirty water. The drain hose runs from the dishwasher to the garbage disposal or the sink drain, and it can kink where it loops up under the sink, or clog where it meets the disposal. Pull the hose off at the disposal end and check for a blockage, and make sure the high loop under the sink is still in place — the loop stops dirty water from the sink flowing back into the dishwasher.
A dishwasher that was installed at the same time as a new garbage disposal has one more trap: the disposal has a knockout plug where the dishwasher hose connects, and if the plug was never knocked out, the dishwasher cannot drain at all. This shows up on the very first wash after the disposal is fitted. The garbage disposal repair page on this site explains the connection, and a technician can clear the plug in a few minutes. If the hose is clear and the disposal is open and the water still stands, the drain pump itself has failed, and that is a repair visit.
Detergent and water temperature
Too much detergent leaves a film on the dishes, and too little leaves food behind. The right amount depends on the detergent and the water, and the measuring line on the dispenser is the place to start. Pods and tablets are measured already, so if you use them, the problem is more likely the water temperature or the filter than the dose. Do not add extra detergent to fix dirty dishes — it makes the film worse, and the film is what turns glasses cloudy.
The water must be hot enough for the detergent to work. A dishwasher fills from the hot water supply, and if the water at the kitchen tap takes a long time to run hot, the dishwasher fills with lukewarm water and the detergent never fully dissolves. Run the hot tap until the water is hot before you start the dishwasher, and check that the water heater is set high enough for the machine. In a cold Massachusetts winter, a dishwasher in an unheated space can fill with water that is colder than usual, and the first cycle of the day is the one that suffers most.
Loading and the door seal
A dishwasher can only clean what the water can reach. Tall items in the bottom rack block the upper spray arm, bowls stacked inside each other trap dirty water, and a cutting board leaning against the side stops the arm from spinning. Load plates facing the centre, keep tall items at the sides of the bottom rack, and leave a gap between bowls so the water can get inside them. If the top rack always comes out dirty and the bottom rack is clean, the loading is blocking the upper arm.
The door seal is the rubber gasket around the door, and when it wears or hardens it lets water out and steam in unevenly. A seal that leaks shows up as water on the floor in front of the machine, and a seal that has gone hard can let the door sit slightly open, which drops the temperature inside the tub. Clean the seal with warm soapy water and dry it fully — sticky residue stops it gripping. A torn seal needs replacing, and the replacement must match the model.
Massachusetts homes: older kitchens and seasonal houses
A dishwasher in a seasonal house has the opposite problem: months of standing still. Seals dry out, the pump can stick, and the first wash of the season can leave water standing or dishes dirty. Run a short empty cycle with hot water before the first full load of the season, and leave the door open a crack between visits so the tub dries. If the machine still will not clean after a filter clean and a hot empty cycle, the fault is inside — the pump, the motor, or the control — and the repair or replace guide helps with the decision when the part turns out to be a major one. For the drain itself, the cost factors page explains what decides the cost of a repair visit, without prices.
Frequently asked questions
Why are my glasses cloudy after the dishwasher?
Cloudy glasses usually come from too much detergent, water that is not hot enough, or a filter that needs cleaning. Use the measured dose, run the hot tap before starting, and clean the filter every week.
Why is there standing water at the bottom of my dishwasher?
The drain hose is kinked or clogged, the garbage disposal knockout plug was never removed, or the drain pump has failed. Check the hose and the disposal connection first, then call for a repair if the water still stands.
Why does my dishwasher smell bad?
Food caught in the filter and the sump is the usual cause. Clean the filter and the sump, then run a hot empty cycle. Leave the door open a crack between washes so the tub dries.
Why does my dishwasher not clean the top rack?
The upper spray arm is blocked, or tall items in the bottom rack are stopping it from spinning. Clean the arm holes, spin the arm by hand to check it turns freely, and keep tall items at the sides.
Should I rinse dishes before loading them?
Scrape them, do not rinse them fully. A little food on the plates helps the detergent work. Rinsing them clean leaves the detergent with nothing to grip, and the dishes can come out dirtier than they went in.
More from the Blog
Appliance trouble at home?
Call now — describe the problem and get a straight answer about what happens next.